![]() ![]() Software version error (M2x miner with M3x firmware, or M3x with M2x firmware) Updating the latest firmware.Check whether the control board screw is locked properlyĬheck the network or mining pools settingĬheck the network or mining pool setting, and the mining setting of the cryptocurrencyĬheck input voltage, network environment, and ambient temperature Upgrade the corresponding type of firmware Performance mode needs to be ontrolled below 30 ℃ ![]() If the ambient temperature is too high in high performance mode, return to normal mode Replace the hash board and place the hash boards which reported the same error together Plug in the adapter plate, and then screw in the power connection hash board again Replace the bad chip in the print position If the chip type of the hash board is inconsistent, replace the correct hash board.Ĭheck the adapter board wiring and cablc, or replace the control board to check whether the hash board connector is soldered Inconsistent, replace the correct hashboard The temperature of the hash board is overheatingĬheck adapter board and wiring contacts.Upgrade firmware SM2 board temperature sensor communication errorĬheck the environment temperature (Recommend to use the GS320 infrared thermometer) SM1 board temperature sensor communication error SM0 board temperature sensor communication errorĬheck if the control panel screws are locked, check the adapter plate and the cable contacts Meaning of Error Code and Corresponding Solutions on WhatsMiner Tool 2 Inspection of input voltage in power gridĬheck if the power fan is blocked and may need to be replaced Try to power off and restart, no effect to replace the power supplyĬheck whether the screws of the control board are lockedĬheck the ambient temperature, check the copper bar screw Input over current protection of power supply primary side Over-temperature Protection for Power Input Over-tempcrature Protection for Power Input Please check the environment temperature and the copper wire screw(Recommend to use the protable electric screwdriver) Overtemperature Protection of Power Output Increase input voltage,replace power supply ![]() Power input voltage is lower than 230V for high power mode Power input voltage and current do not match the power Improve power supply conditions and input voltage Updating to the latest software or check the power supply Power does not match the configuration file Meaning of Error Code and Corresponding Solutions on WhatsM liner Tool 1Ĭheck whether the fan connction is normal, or replace the power supply, or replace the fanĭetecting the power output cable, or updating the latest firmware, or replacing the power supply For rest of the problems, Kindly reach us and we’re willing to help. We hope it is helpful for all WhatsMiner users. Here is the WhatsMiner checklist of error code and we strongly recommend every WhatsMiner user to keep it because almost 80% of the problems can be solved by corresponding solutions. How to deal with fault codes of Whatsminer series ![]()
0 Comments
Leave a Reply. |